AU Doc
08-02-2018, 08:09 AM
I just finished mounting my corvette regulator-filter on a 69 Camaro with an LS2 swap. I mounted just in front of my tank, and when I was sitting back admiring my handy work I realized I'm not sure where my exhaust is going to route.
I've googled this a bit, but I'm curious where everyone else has been mounting their regulator-filter.
Here's where I mounted it. At the top is the chunk on the rear and the bottom is the gas tank. On the left is the frame rail. I'll probably use the Holley exhaust, and I'm a little worried it routes over the rear end right about where I have the regulator.
155211
I've googled this a bit, but I'm curious where everyone else has been mounting their regulator-filter.
Here's where I mounted it. At the top is the chunk on the rear and the bottom is the gas tank. On the left is the frame rail. I'll probably use the Holley exhaust, and I'm a little worried it routes over the rear end right about where I have the regulator.
155211