Mean 69
09-13-2017, 01:05 PM
I have a set of Edelbrock Performer RPM heads that I took off of my car to go a bit bit bigger in power. They are old castings, probably fifteen years old, but the heads have virtually no time on them. Built a 489 for a Chevelle I had, then sold the car right after but kept the engine and it sat for fourteen years. Had the engine refreshed and put into my current car, and ran that for last year or so on weekends. Heads probably have less than 2k miles on them total. They are currently set up for hydraulic roller cam, have some slight pocket porting, and one has a helicoil in one of the intake manifold holes due to stripped thread.
Also have Eddy Performer RPM intake (not the air gap style, so it will fit under most hoods), and a Holley HP Series 750 Vac Secondary carb to go with it. The carb is only two years old and is stock except for jetting.
Asking $1800 for all. This combo was a really fun setup and made tons of bottom end torque, perfect for a heavy street strip combo.
Drop a PM for pics and any other info.
Mark
Also have Eddy Performer RPM intake (not the air gap style, so it will fit under most hoods), and a Holley HP Series 750 Vac Secondary carb to go with it. The carb is only two years old and is stock except for jetting.
Asking $1800 for all. This combo was a really fun setup and made tons of bottom end torque, perfect for a heavy street strip combo.
Drop a PM for pics and any other info.
Mark