LSA, LS3 Chassisworks front Sub 69 Camaro

[joeko23]

Hey Guys,

I am putting an LSA and TR6060 into a 69 Camaro with a Chassiswork front subframe, anyone have a similar combination? I want to know which tranny crossmember I should use? The T56 one? Also which headers?

I tried reaching out to Chassisworks tech department, but they didnt seem very sure. Their reply was "we have had some people use Hooker, but it may have changed, stainless works and kooks have been reported to work too I think". That's a direct email quote from their tech department.

Any help would be greatly appreciated!

[mikekirby1]

I used the stainlessworks headers for the Wayne Due subframe and they fit perfect. There was a small tab to be cutoff on the passenger side of the subframe but that was it. I also have the chassisworks billet motor mounts and the t-56 Crossmember.

[badazz81z28]

This is one of the reasons I went Detroit Speed. It can be a headache trying to mix and match parts.