chevelletiger
06-02-2016, 01:56 PM
1/2 thick milling machined steel brake brackets to adapt c5/c6 calipers to 2nd gen camaro stock spindles.
I made these for a camaro i was going to get but the sale didnt happen.
These have been beadblasted and are raw steel.
$50.00 +s&h buyer need hardware,which i will tell buyer what sizes they need.
These where made off of a kore3 bracket someone gave me so the dimensions are the same,they just need paint.
Phil
I made these for a camaro i was going to get but the sale didnt happen.
These have been beadblasted and are raw steel.
$50.00 +s&h buyer need hardware,which i will tell buyer what sizes they need.
These where made off of a kore3 bracket someone gave me so the dimensions are the same,they just need paint.
Phil