PDA

View Full Version : LS2 swap starting issue



davidomilligan
01-29-2016, 11:44 PM
ok so I have a ls2 engine with a holley ecu and harness... when I key the ignition on I have power at the coils but it shuts off after five seconds with the fuel pump....is that correct? when I crank the engine I get power to the coils again only issue is it actually goes to my wires and plugs. I cant figure it out. any ideas?

rohrt
01-30-2016, 05:57 AM
Sounds like the anti-theft to me.

davidomilligan
01-30-2016, 08:16 AM
i have a holley ecu and harness cant be anti theft

davidomilligan
01-30-2016, 09:28 PM
figured it out my starter wasn't liking my battery being in the trunk with the 2 gauge wire I was running. I put it in the engine bay with shorter 2 gauge wire and it fired right up

dirty rick
01-31-2016, 08:04 AM
Use welding cable for rear battery location.