WTB: first gen camaro flush glass kit

[slimjim]

Hey all,
my car is going through the fabrication stage, so of course, we want fit the rear glass now before we paint to ensure a good fit, however I was never aware of how hard these kits are to come by, the only places I have located them are classic industries for $1999 (out of stock) and fesler for $1499 (out of stock until december).
If anyone is aware of another supplier of these kits it would be much appreciated.

We will discuss the option of flush mounting the stock glass also.
There is a chance we can keep ourselves busy on all other aspects of the car and wait until december to paint it, but of course, the sooner the better..

Hope you guys can help,
James

[jonesbs9]

good luck with that... after being postponed a few times and seeing some ill fitting mouldings that a few products used. I bought me three different sizes of square key stock and flush mounted the original glass. MY rear window is done and the front is done except for making the filler below the glass, along the cowl. Its actually not that hard, and you can get rid of the rubber moulding all together...much cleaner looking

[slimjim]

good luck with that... after being postponed a few times and seeing some ill fitting mouldings that a few products used. I bought me three different sizes of square key stock and flush mounted the original glass. MY rear window is done and the front is done except for making the filler below the glass, along the cowl. Its actually not that hard, and you can get rid of the rubber moulding all together...much cleaner looking

Ive been starting to figure as much, unless someone comes in with a solution soon, I'm gonna start doing the same as you, thanks for your help

[thumper877]

Got any pics of ur trim u made Jones always nice for ideals thanks