Mr Nick
08-02-2015, 11:30 AM
I am having the vinyl top put back on, along with a few other minor items (pass side mirror, some missing interior trim, etc).
I spoke with the body shop and they remove the rear glass as part of the vinyl top install, and we both agreed that would be a great way to tint the back glass on the bench. This would allow a super clean and easy install, right up to the edge of the glass, leaving just enough bare glass for the urethane to re-install. Once installed there would be no noticeable edge on the tint.
The body shop farms out the tint work to a local shop, when they spoke the tint shop said they would NOT tint the glass on the bench, because it would get dust on the glass. He is only willing to tint the glass while it's installed. The body shop manager any myself don't really understand the logic. If he's concerned about dust falling down onto the glass while working, then have somebody hold it upright. That would be the same as tinting the upright glass in any door.
So, my question is this... Those of you with tinted A-bodies (or any other vehicle with similar interior and exterior trim around rear glass) how did the shop tint the glass? Installed or removed? And can you see an edge?
Thanks!
I spoke with the body shop and they remove the rear glass as part of the vinyl top install, and we both agreed that would be a great way to tint the back glass on the bench. This would allow a super clean and easy install, right up to the edge of the glass, leaving just enough bare glass for the urethane to re-install. Once installed there would be no noticeable edge on the tint.
The body shop farms out the tint work to a local shop, when they spoke the tint shop said they would NOT tint the glass on the bench, because it would get dust on the glass. He is only willing to tint the glass while it's installed. The body shop manager any myself don't really understand the logic. If he's concerned about dust falling down onto the glass while working, then have somebody hold it upright. That would be the same as tinting the upright glass in any door.
So, my question is this... Those of you with tinted A-bodies (or any other vehicle with similar interior and exterior trim around rear glass) how did the shop tint the glass? Installed or removed? And can you see an edge?
Thanks!