balancer install tool for LS3

[XLexusTech]

Looking for advice on a good quality tool. I have seen a few threads about DIY installer made of threaded rod.. but I also see a few about threads getting crushed and breaking in the crank..

anyone have a tool recommendation?

[ChevelleNV]

I have one I bought from ATI, it was a bit expensive... but worth every penny..

[ChevelleNV]

http://www.atiracing.com/products/dampers/damperparts/index.htm

Puller / Installer Pro Kit - 918999
Installation Stud for LS1, LS2, LS6, LS7 & LS9 - 918999SC

[Reckn8]

I have one from Colorado Speed. Works perfect.

[GNon18s]

I made one out of threaded rod (all-thread), and two nuts/washers. ..worked perfectly on my project and my friends projects. No need to spend big money on this.