Tie rod replacements??

[4RS FED]

Looking into my engine compartment everything is nice. But then you have the steering linkage. Anyone make stuff out of tubing and clevis ends before??

Suggestions or comments??

figure they are lighter and look nicer, obviously a rack and pinion would solve the problem, but at this point in time, it isnt in the cards

Thanks
Rob
4RS FED
1973 turbo camaro RS

[Andrew McBride]

http://www.speedtech-performance.com/us%20dialup/low%20Tie%20rod%20sleeves.htm
http://www.detroitspeed.com/09010210.html
maybe something like this? I am not sure exactly what you are looking for.

[4RS FED]

no i was thinking of somethig like a panhard bar, tubing compltelty instead of ball joints??

make any sense??

[4RS FED]

no other ideas :candle:

[David Pozzi]

Yes, don't do it! :spank2:

[Lowend]

The Baer Trackers are a very nice look...
Hiem Joint with a Cast reverse threaded sleeve for outer tie rod

Custom Alignment in Mountain View offers their own version

[4RS FED]

any new ideas :ssst: