PDA

View Full Version : Dynamat installation



mdprovee
09-06-2005, 08:25 AM
Well my little helper and I installed the dynamat over the weekend. I need another box to finish.

F70t/a
09-06-2005, 08:59 AM
Looking good :)

rockdogz
09-06-2005, 01:22 PM
Hey, looks like that guy does good work... is he for hire??

:)

black67ls1
09-21-2005, 12:17 PM
On my 67 Camaro I did the roof and firewall/cowl with two tri packs (12 sq ft each). The roof isn't covered completely. There's about 2 inches along both sides of the roof that aren't covered. Before the dynamat the roof rang like a bell when you tap it with your knuckle, now there's just a thud. As for the firewall/cowl, I covered from right behind the windshield molding down to the flat ledge on the passenger side and then down to the floor on the driver's side.

I still have the bulk pak that I haven't opened yet. Do you think it will cover the floor and tunnel up to where I mentioned?

68BNUT
09-21-2005, 12:29 PM
I bet he's a good helper you just have to make sure he doesnt drool on the adhesive! :drool:

mdprovee
09-21-2005, 01:06 PM
black67ls1

I use the bulk pac and went from where the firewall meets the cowl to the rear seat foot wells. If you have the firewall partial done, just a guess but your bulk pac should get you to the floor under the rear seat.