UNBROKEN
09-01-2013, 08:24 PM
I know the bar ends should be parallel with the lower control arm...but how bad does it affect things if that's just not possible?
The ends face rearward and point upwards. I can't move the frame mounts up any higher and I've already made the end links as short as I possibly can. For it to be parallel the bar would occupy the same space as the rack and pinion parts/tie rods/etc. I haven't measure but I'd guess that in a 9-10" span the ends are up about 2-2.5".
For the rear bar I made adjustable end links with heims and have it parallel to the ground....this front bar bugs the hell out of me though. Is it really a big deal?
The ends face rearward and point upwards. I can't move the frame mounts up any higher and I've already made the end links as short as I possibly can. For it to be parallel the bar would occupy the same space as the rack and pinion parts/tie rods/etc. I haven't measure but I'd guess that in a 9-10" span the ends are up about 2-2.5".
For the rear bar I made adjustable end links with heims and have it parallel to the ground....this front bar bugs the hell out of me though. Is it really a big deal?