View Full Version : )9 Camaro rear axle
Gregster
08-21-2013, 06:17 PM
Would a 47" width axle flange to axle flange be to narrow with a typical minitub? Was hoping to buy already narrowed.
wayward
08-21-2013, 07:14 PM
I have always been advised to start with your wheels and brake setups to then figure the housing and axels from that.
g-machine
08-21-2013, 07:36 PM
I'm not sure what year Camaro this is for, but it seems a bit narrow. 2" narrowed per side is a good starting point.
MuscleRodz
08-21-2013, 07:41 PM
way to narrow
Schwartz Performance
08-21-2013, 08:45 PM
You don't need a narrowed rear end for minitub.. That just gives you a deeper dish on the wheels.
-Dale
Powered by vBulletin®