Activity Stream

Yes Sir! Probably after the 1st of the year. To much going on right now!

Thank you for the reply!

You'd be surprised how much a difference 1" of drop makes.

Hence the need to use a battery cable sized wire. Low impedance wire connected to a low impedance battery implies the end of the wire is essentially...

If you look back at that green car I posted on the last page, it has that 1" block installed as well. From the looks of it, your car will sit very...

I would still be concerned about dirty/noisey electrical wires running right with/parallel to clean power wires. If the power wire from your...

This is exactly what this spindle does, it uses the GM D-52 caliper which is what was used on second gen F-bodies and many other GM cars. this...

The Sniper needs to control the fuel pump as far as I know. Same as the GM ECM. Can’t you just splice the Holley fuel pump wire to the one you...

Yeah I'd say that's a fair price. Shouldn't be too hard to sell

Wow! What a setup. Very functional

No I meant caliper. Doing too many things this afternoon so that was a typo. A version with a stock second gen caliper bolt pattern and the...

I have stoptech 6 pistons and 14” rotors under the same wheels. No problem.

A hypothetical car is worth $50k. Some 19yo kid offers the owner $5k for it. The owner laughs. The kid doesn't get the sale. It means...

Ok got the tall b joints in. Also, I added the leaf top clamping plate. Visually, it does look like it was lowered a little. Ordering the Ride Tech...

Some tiny progress this week. Swapped out the sn95 mustang spindles for the 14 taurus sho spindles. A big plus for the brakes were the 14 inch...

Don't know how that works...:dunno:

A lot of people use old house ovens, bit I don't have the floor space for it. This oven was big enough to do my lower control arms and calipers.

What do you think about the fuel pump wiring? I had run a wire from the AAW to the trunk when the car got wired. All I’d need to do is pop the fuse...

what motor you running? Forged pistons? The reason I'm asking is about 35 years ago I built a 350 with forged pistons. I didn't like the way they...

Not really understanding the question, do you mean rotor? if so the answer is no but the 88-92 1LE 12" rotor is 5 x 4.75 bolt pattern.

Alan, I know there are different paint offerings from catalogs that may include the correct paint and colors to refinish the bezels. It will take...

Love it!

Looks great!

New rubber is on - as a reminder from above it's 18x8 fronts with 245/45/18 Michelin Pilot 4S and 18x10 rear with Nitto 555r drag radials 305/40/18. ...

That will be fine imho. I have done it that way on multiple builds. The issues arise when guys use 14 gauge wire etc. This is a controversial...

Your approach is fine if the wire gauge is large enough imho. Skimp on that wire gauge and you could create problems. I would use battery cable....

Thanks, this is how I was hoping to wire it. I have a 00 cable that goes directly from the trunk mounted battery to the firewall where I could pull...

I am no expert, but I believe you only calculate piston size on one side of the caliper, so 2 1/4" X 2 for area. That Cerakote looks awesome!