After a lot of thought I decided that I had to modify the forward cross member on the rear frame center section to add an exhaust pass thru on either...
The basic top layout of the center section is a "picture frame" made from 2 x 3 x .125" tube and the mounting brackets are all made from 3/16" plate....
I took the subframe out from under the car to start fabricating the rear frame. In an effort to keep things as compact as reasonably possible, I got...
I was just going to touch on that myself. The lower LB rating would be fine for any hobby cars I have but I decided to spend a few more $ and get the...
That kid with the hammer is going to be shaving before you’re done! As an earlier poster said, “Dance, monkey, dance!” We need more content if we’re...