Activity Stream

Hmm, may not be the way forward here then. The search continues. Thanks, appreciate it.

I think I found the 68 you are referring too. https://www.vintage-mustang.com/threads/awd-mustang-1968-convertible-build.663780/page-12 Is...

Donny, thanks for the info on the noise transmission you experienced on your Mustang, i think a lot of my noise is transmitted this way too. - - -...

There's nothing special about the wheel designs that this manufacturer has, but it has a good review when it comes to the quality of the wheel. Their...

Careful, those ducts might suck in small children...lol

Yes a gear whine, near a 100kph with a slight addition of power and the noise stops, then returns on coast. second set of new bearings as well. ...

Front brake air intakes are ready for paint just need to install the bumper and do any final adjustments to them. Thanks Pat

I would say it depends where you live in relation to how many street lights/stops you have to deal with and if there are freeways or just highways.

Man. I wish I wasnt selling my TA

I don't have first hand experience with them but I see those wheels from time to time. I saw a Viper with a killer wheel fitment and they were BC...

Thanks for sharing! Those look great! Yes sir! Car people are the best people!

thanks, will definitely be one of the best 55 built if it’s finished off right!

The sharp eyed amongst you will notice a change in the name of the thread. Apparently a robot decided that like the car itself, the thread title was...

One of the things I have done to quiet things down is to replace the cardboard trunk divider with Dynamat covered aluminum sheet cut to an exact fit...

Install of the RICKS EFI gas tank...we really like these tanks.

Thanks...we think it looks good too. We've done a few cars now with Fesler glass, makes for a clean look.

sending PM as well

Just took out our close ratio and put in a wide ratio. Much better for regular street driving!

The carbon fiber shims may cause corrosion. Make sure you have paint any where the metal (bolts) touch. I cant remember but I think stainless steel...

3:73 gears are noisy. The heim joints only make it worse by transferring it through the whole car. You can swap the adjustable end back to rubber...

Maybe...but I didn't have any other torch besides the map gas torch that I bought, thinking it would be enough. I am not using those plates again, so...

weird ,is it a gear whine or a bearing you think .... ( were all bearings changed when the different gear sets were changed )

sent mesage

I want to think a larger torch with either wax or a pentrating oil and some time to let it cool to allow thermal upset to take place those bolt would...

https://www.corvetteforum.com/forums/autocrossing-and-roadracing/4414948-from-complete-scratch-c5-full-suspension-measurements-and-calculations.html...