Activity Stream

Wrapping up all items that will hold up Upholstery.

Sold..........

I hit kijiii almost daily ...sometimes I find good deals. As for a 3 series 3.55 id say set up a notification on kijii for them here in Ontario if...

Something just doesn't seem right... Are these inner tie rods reversed? If so, this would mean they had been incorrectly installed this...

No build thread for the chevelle. I upgraded to a you tube channel. https://www.youtube.com/@RecycledRacing I added the speedtech frame brace...

Never on studs.... maybe on the back of a cast aluminum wheel hub. Only use sparingly on spark plugs, even though some mfr's supposedly take care...

Complete rewire of the race truck with Digital Delay relay panel and switch panel, along with MSD Grid and crank trigger. My 68 Camaro needs rewired...

Wow, that's still a pretty tight fit... Here's the new idler arm from Classic Industries. It's an improvement, but not much room left. ...

Very cool, send your build thread for your chevelle if you have one started! My only tip of advice for the frame is DEFINITELY box the c-channel...

Thank You, I guess I did not fully understand your original reply.

That is what I was suggesting above. The epoxy will cure. At least the SPI epoxy I use will cure. It sands nice too. Don

Old tread i know!. How did these work out for you? I am doing a tilting would bed on a c10 build. Wondering if these have enough spring pressure...

'67 Camaro true RS/SS but drive train long gone. It's going to get an LSx, T56, 12 bolt drive train; composite leafs, Watts link (maybe sway bar...

swapping out a 1 piece rear main seal this weekend. Just bought a trans jack. Hopefully everything will go smooth.

What do you think about cleaning everything possible and then lightly pouring epoxy into this seam and brushing off any excess? Do you think it would...

1960 MGA Coupe

Not the time for the moment to build something better but it hides all the cables

I'm located in Calgary. I was born and spent most of my life in southern Ontario. Any luck on sourcing parts in your neck of the woods. I am trying...

very clean!

Qualcomm was a great venue. The CAM guys were awesome also. I will keep an eye on your build closely as I'm building a chevelle now also. I went...

Interior put in this week by local upholster in Chandler Arizona. Jeremy J.

O&S tightened the exhaust flanges on the collectors and it runs better. It's not there yet but I have a small leak to deal with. I ran the wiring to...

Man, that thing is looking SWEEEET!

Back to the shop today. They are finishing up the interior and a little more work on the rear power windows.

Not what I would call deep rust but not light either. It was enough to start lifting the seam sealer in a couple small spots.

Deep corrosive rust or just light surface rust? If it’s deep corrosive rust you pretty much need to remove the roof skin to get access. If it’s...

My ‘61 Biscayne It’s still a work in progress