I’m searching high and low for the adapter on this shifter. Did the buyer take it? Use it?

Love the color, was really burned out on it through the 70/80/90 but nice to see it again,

If you sold one of your "high dollar pro-touring builds" here on this site!!!! A couple of dollars out of your pocket would help with the sites...

Here are the details. LS3 Quick Time Bellhousing T56 Magnum narrow ratio McCloud twin disc clutch. Hydramax throw out bearing the...

9.5” wheel with a 275 tire is pretty much max for a 69. You will need to nail the backspacing and probably trim the lip back to the spot welds with...

I've been building transmission for over 30 years, but I will tell you that I don't know what crank shaft end play should be. I would measure it...

Figured out a better intake manifold to fit under the stock hood. Have some very tight clearances but ... they fit. Overall Spacing up the...

What are these wheels? Is it Minitubbed? looking for a setup for my 69. Not sure how big/wide I can go without a minitub

my bar isn't perfect. about 2 thou of bow to it, however i'm holding 1 end of the bar on the Throw-out bearing and measuring from the same part of...

I sprayed the bottom with raptor liner tinted to body color.

Holley Term X is SOLD

Sold

Glad you finally took the plunge. Hope you enjoy your decision, the forum is great for all the questions you might have.

Welcome to the forum Gary, ��. Larry’s a pretty awesome mod and the forum is an awesome resource for information. Goodluck ��

Welcome aboard Lulilistc, it’s a real pleasure to meet you. Glad you found us ��, hope you have fun and stay around for much longer.

Congrats on your build 🎉, that looks super impressive. Welcome to the forum, it’s a real pleasure to make your acquaintance.

Congratulations on your purchase 🎉, hope you have fun with her. Real pleasure to make your acquaintance, welcome to the forum…

You’re welcome, and congrats �� on your purchase. Hope you stay for more information

Thanks for the replies, it will be a few years down the road before I'm ready to add ABS, just trying to make sure it's worked into the overall plan....

Was the dryer open to the atmosphere for some time or was it sealed and installed quickly? If open to the air for a while the desiccant in it might...

So a couple things... The evacuation process sounds a bit suspect. IIRC, when I did mine I was able to get at least 29 inHg. Anything less...

Pm sent for Holley X

Putting the condenser between the radiator and fan will mean that it is getting hot air from the radiator. Bad idea, there’s a reason they are always...

Mirrors are sold.

Hey guys! Guess what I'm working on right now.... - - - Updated - - - Hey guys! Guess what I'm working on right now.... - - - Updated - - -...