Activity Stream

Yeah it’s weird. Doors started to act up lol. Even the pass door doesn’t shut well. To shut, id have to lift the door up, and shut hard lol. I think...

Probably. I have the block still. I can take a look !

Sale pending ...

Can you give me a shipped price to 94954 please

Got some work done on the Blazer today but it might be a few weeks before I can touch it again. After having my tube bender a year I finally get to...

That’s what I was thinking too, but will gas go bad in a 2 month span? Granted it is the cheap stuff (87) and California.

When I build my Lark, I'm going with a fuel-injected 4.3 GM V-6. The dependability and reliability is the thing for me. I know it's not going to...

NRG 320MM Flat Bottom Shiny Carbon Pt # ST-009 CF/BK

Ya I agree on the accusump. Good protection but i initially didn’t think I needed it with my setup. Kinda chasing my tail now and will just have to...

I guess I'm ignorant, but what do these fit?

Or a spark plug misfire. It can happen at idle with a lean mixture. Look at your TPS signal stability at idle. If TPS varies, the ECM will react as...

Survey..... How do you guys feel about my old school carbureted 427 side oiler engine vs say a new coyote or Voodoo engine? I personally like the...

Finally some photos. So in summary the rotors are being used along the outside circumference (the pad is only contacting the outside edge of the...

bad gas?

Feel free to reach out to my email if you'd like me to send the photos to you directly. Sometimes links are weird like that. I've added a shot of...

Congrats. Where’s it headed ?

I agree. 19-20” doesn’t look right on a chevelle or Camaro IMO. 18”. 245/275 or whatever fits. I run 275/295 on my second gen Camaro on 18x10s.

I think you are spot on in the bottom end is getting starved - too much oil on top end. Of course that doesn’t explain the pushrod failure does...

Thank you!

Yes I definitely agree with you and didn’t run one before because I thought with my road race trap door baffled pan, large volume, and cooler I would...

Those of you quoting prices, if you could put it into hours it would be more helpful now and in the future. I would estimate it at 100 hours.

New passenger side trunk floor side panel and DSE inner tub cleco install and driver's side metal removal. More detailed pictures to come tomorrow.

bump

bump

Fantaastic Build! Great attention to detail in regard to the the roof repairs and exquisite body work! :drive1:

Yes

If I bought an engine from a well regarded shop and specified what I was doing with the car, I would expect the engine builder to spec it...