Activity Stream

bump

About 3.25” but gets deeper the higher you go.

It was…I dont remember the exact size but you can google “GM type II power steering pump AN fitting” and find what you need.

Do you remember what A/N Fittings you had to use on the PS unit? I assume it's an adapter of some type. I think I found them. ...

I can only speak to the accessory drive on the Corvette 327, but I was able to get everything to line up perfectly but running the power steering...

Don't want to derail the start of a great build thread but I have to ask: Andrew, do you know if the 8HP would fit in the stock trans tunnel on a...

Where are you located?

The good ones add caster and keep the wheel centered in the opening. They will also have the proper angle in the mounts for the tall spindle or tall...

I have one I can sell you. It’s not going to be cheap neither is shipping.

I have one! PM me

I have a pair!

Why not just buy them from Frank?

What geometry issues do tubular arms fix?

this one comes with a pulley. https://www.speedwaymotors.com/Aluminum-Power-Steering-Pump-With-Pulley,487211.html I know the issue...

Tech is a tool and with any tool, the better you become accustomed to it, the better the outcome. I understand what you said about pushing the...

That's a work of art!

The type II pump did not come with a pulley as the normal LS set up uses a ribbed belt as opposed to the old school v-groove belt. I believe the...

Doug, Question about your PowerSteering setup. Did the GEN typeII pump come with the Pulley, and is there a difference on the what PS pump...

Hi just wondering if u every found a camaro. If still interested i have one for sale. Let me know and I will send info thanks

What steering box are you using and there are several choices for motor/transmission mounts to consider.

I'm eyeballing these, but the backspacing isn't ideal. They have an 18x9.5 but with a 5.25 backspacing....

Yeah I'm torn with this. If it were already rusty it wouldn't be a big deal, but it's really nice in there. Then again, it's not that difficult to...

Great. I will probably just do a coil over conversion then, and rebuild the stock A arms and control arms. We do powdercoating at work so I will...

Camshaft, full exhaust and a tune will really wake it up

Good choice. Andrew

Refurbished stock control arms with bushings are fine for that. Andrew

Backfill the block using the upper radiator hose. Andrew

If this is a real Judge, then you may want to use the TKX. Then again, it is your car and you can do whatever you like. Andrew

Nice ride! Andrew

If this is going to be used for an engine harness, then I would strongly reconsider using bulkheads, unless this is a pure race car and the engine...