Activity Stream

I believe you are quite right. Been so long since I heard the name, went brain dead writing the first post.

Sold

Sold

What did you do to modify the automatic console bezel for the manual shifter? I've debated putting a 68-72 console in since it has the center...

Since I decided to rotate the Holley Lo-Ram base front to back, I needed to add a fitting for the catch can. Instead of using the typical NPT to AN...

Thank you. I thought about doing that but I like the knob on the top because its accessible through the trunk, so i don't have to get on the ground...

Now flip the shock over to make mounting the resi easier, and so the hose or fittings don’t get torn off. Looks good!!!

It almost looks like i did all the proper measurements (i didnt, absolutely none LOL), clearances out back are PERFECT with the fuel cell mocked up....

I See said the blind man, got it, much appreciated

I think the company you are thinking of is ATS for the spindles.

Lmao pretty sure the mods can and will dismiss this one

Look at line 4 (4th gear set to 1), at 11 mph it's spinning 500 rpm, 21mph 1000 rpm, etc. Think you'll be safe if you don't have plans to exceed...

3.73 rp 275 40 18 26.7" rw diameter

What rear gear and rear tire size are you running?

\ Yes once the roll cage and interior support frame is removed, I will then weld the body on, alone with the flat bottom floors to form a belly pan...

Tried it but not sure what im looking for can you assist with image below? Strange has a handy chart, see below.

Use this calculator, plug in your tire size, rear gear, and set one of the trans gears to 1. https://www.blocklayer.com/rpm-gear Then scroll to...

Sweet idea! I think I would weld the body to the frame, making it a unibody. Can't wait to see more!

Wow! I'm impressed. Following

I hope Vic is enjoying this project. Many projects are just work. If the creativity to accomplish things is important, he should be happy. :)

- - - Updated - - -

Define "road racing." If you are actually racing, wheel to wheel with a high probability of getting punted of the track, you should really use a...

Nicely done sir, this is what hot rodding is about, I love to learn new things from other car guys. I’ve got to look in to that pressure sensor from...

Honestly I'm not sure, I'll have to look into that

Thanks raustinss.