Moser 12 bolt axle bearing

[68lovebuzz]

Hello everybody,

Thanks ahead of time for answering my question; It may be obvious for some!



I ordered a moser 12 bolt with c clip eliminator, bolt-in axles. I tried installing the axles tonight only to notice the bearing pressed on to each axle sticks out nearly 1/8" past the bearing end welded on the axle tubes - (The bearing itself when installed is not flush with the brake mounting surface at end of cap). Does this have any significance at all? Am i over thinking this? Should I Just bold the retainer on an call it good? Thanks for your 2 cents on this matter.

These two shots show the bearing end and bearing pressed on the axle just as they were shipped.