Monroe Handler

[feeble]

Thanks for the comments everyone.

are you using Solidworks?

I use Inventor.


Nothing to report on the chassis or front suspension, I am still tinkering with the basics and getting parts modeled up so I can do the design.

I did get the dual quad top to my Clevor (Boss 302) EFI tunnel ram base this week. The engine is a long ways off but I am slowly collecting parts. Not sure if I'm going to put duad throttle bodies on top or modify the intake top to have a single throttle body in the front. Both ideas appeal to me for different reasons. I haven't completely ruled out a Coyote swap yet either.







Does a street fighter / pro-touring style 70s car with a 70s body kit "fit" well with a 70s intake w/ EFI sticking through the hood or is it too much? Or is too much just right?