Results 1 to 1 of 1
-
07-08-2010 #1Registered User
- Join Date
- Oct 2009
- Location
- Southeastern Michigan
- Posts
- 99
G-body initial setup sanity check
I need to order a driveshaft. First I need to get my suspension geometry somewhat in order. Here's my plan, let me know if I'm on the right track or not. Car has LS1 swap and Currie-trac upper and lower arms. Car is on jackstands until July 15th.
- level car on stands, verify on frame rails below door using bubble level.
- set driveline angle to downward 3-4*
- set pinion angle downward 3-4*
- verify upper control arms are adjusted at same length by measuring the attachment points.
- Torque fasteners after adjustments are set
- get weight of car on suspension with jackstands under rear axles and stands/blocks under front A-arms
- measure driveshaft (following vendor instructions)
Thanks for bearing with the noob post. I only want to buy one driveshaft.
-