Results 1 to 20 of 24
-
08-06-2008 #1
Camshaft Suggestion - from Comp Cams - thoughts?
Ok, so I've gotta get a new camshaft because I rounded off a lobe on the old one. I filled out the form on Comp Cams website and they got back to me with this recommendation.
I think it might be too much for my car. What do you guys think?
Car specs.
358 SBC
EDELBROCK PERFORMER RPM HEADS
LT-1 port matched factory manfold
780 Holley Street performer carb
HEADERS
MUNCIE M-21 4 speed
3.55 rear end
Comp Cams XR294HR-10
INTAKE MASTER 3317S
EXHAUST MASTER 3318S
ENGINE CS XR294HR-10
GRIND NUMBER CS XR294HR-10
INT EXH
HYDRAULIC Y/N YES DUR @.050 242 248
INTAKE EXHAUST LOBE LIFT .3600 .3750
VALVE ADJUSTMENT HYD HYD ROCKER RATIO .00 .00
MAX GROSS VALVE LIFT .540 .562
DUR @ .006 TAPPET LIFT 294 300 LOBE SEPARATI 110.0
ADVANCE 4
VALVE TIMING OPEN CLOSE VALVE SPRINGS 987-16
.006 INT 41 73
EXH 84 36
THESE SPECS ARE FOR CAM(S) INSTALLED
106.0 INTAKE CENTERLINE
-
08-06-2008 #2That's pretty big for a 358 with not much gear
1971 Camaro, 383 stroker ~500HP,M21 Trans with lightened flywheel. All Sorts of Auto-x Goodness in the Suspension. 12" Brakes ->SOLD
But ask me about my 2004 STi Auto-x car...
Just call me Brett
08-07-2008 #3Originally Posted by Lowend
08-07-2008 #4