Results 1 to 4 of 4
-
10-11-2008 #1
DSE Deeptub to outer wheel housing alignment
The alignment holes on my DSE Deep tub and US made outer wheelhousing won't line up. The outer housing matches the repro quarter perfectly where it's clamped into place. If I slide the inner housing back to line up the holes, everything gets thrown off a little. Has anyone else had the same issue? Is it super critical that the alignment holes match up?
Nathan
1969 Camaro - 355 sbc, TKO 600, 12 bolt, Global West suspension
-
10-11-2008 #2Registered User- Join Date
- Apr 2006
- Posts
- 1,027
nate, as long as you double/triple check all other fitment i would not lose any sleep over the alignment holes, weld her up. better off to have good fitment, then to have poor fitment but the holes line up
jake
10-12-2008 #32nd the above.
On one side of mine I wasn't able to get the alignment holes to match up perfectly w/o throwing the alignment off elsewhere. I would just use the alignment holes to fine tune if possible.
10-12-2008 #4Registered User- Join Date
- Dec 2004
- Location
- boerne texas
- Posts
- 314
3rd that.
rick k