Fuel filler misaligned

[navyflyer72]

I have a 67 Camaro and a narrowed stainless fuel tank from DS&E, I noticed recently a BAD leak when filling up. After inspecting through the access area behine the license plate I discovered that the rubber hose that attaches the filler tube to the extension tube on the tank had to make a severe bend forward to attach to the tank and was being pulled off of the tank extension causing the leak. I don't think the tank can be moved back any further to align the tank extension with the filler neck, anyone else run into this problem, any ideas on a solution? I was thinking maybe a more flexible connecting hose, but not sure what to use that will withstand the fuel... Any ideas would be helpful.

-George

[icemanrd19]

I'm wondering the same thing now. Im bairly off but still off.

[camrat68]

Shorten up your filler neck on the gas cap end rather than the tank end and run a longer hose rather than the stock coupler hoses.

Something like these...
http://www.speedwaymotors.com/Instal...gth,51119.html

Or an angled hose...
http://www.lmctruck.com/icatalog/cd/full.aspx?Page=108

-Jim

[icemanrd19]

I opened up the hole alittle more and used a 45 degree hose. It bolts up fine now. Well sorta. I need another hose because i cut it slightly too short on one end. lol

[renegade6]

Look for marine filler hose.

[Gratefuldiver]

I got some hose from these guys. You can buy it by the inch or 3' sections in just about every dia



http://www.fillernecksupply.com/servlet/the-Fuel-Filler-Hose-cln-2%22-or-51mm-Diameter-cln-Sold-Per-Inch/Categories