Results 1 to 5 of 5
-
01-02-2017 #1Registered User
- Join Date
- Jan 2017
- Posts
- 3
LS1 Passenger side head mount accessory spacer for LS1?
I have a supercharger kit for an LS1 a corvette (obviously made for the corvette pulley spacing) that I want to mount on my Fbody LS1 with Fbody accessories (spaced out ¾” further from the motor than the corvette). The supercharger mounts to the front of the passenger side head (3 bolts).
Does anyone make a ¾” aluminum spacer to allow bolting up corvette accessories to the Fbody belt spacing? (kinda like the water pump spacers, just for the passenger side head)
I have just put the bolts through a stack of washers that measure ¾” for mocking things up, but will have a better spacer before it runs. I can make one if I have to, but if I can just buy one, I would probably just do that.
-
01-14-2017 #2
Holley makes spacers in different thicknesses for their brackets. You can check them out here https://www.holley.com/products/ls_p...essory_drives/ Here is a picture of the spacer for their A/C bracket that bolts to the passenger head that I used.
1973 Camaro Type LT/RS
http://www.apiem.com/camaro
-
01-21-2017 #3Registered User
- Join Date
- Jan 2017
- Posts
- 3
I tried calling them to see if they had something, and was told they did not have a 3/4" spacer for the passenger side head, they just wanted to sell me a kit for everything, which I don't need. I can't tell where that part would go, or how thick it is. I'm making one out of 3/4" by 1" aluminum bar.
-
01-22-2017 #4