G8GT Rear Seat and Custom Panels Mounted in my '69 Chevelle

[Barrrf]

Here is the 1 good pic of the install I felt I could post up. Never mind the dents, I had the panels sitting against each other before I put them in. The dents in the seat are from my kids car seats. Thoughts on these? You'll notice no winder crank - I have a slot cut out of the subpanel for a push button, I just havent done the power window conversion yet.



Disclaimer: I used the wrong type of foam under the soft touch covers - so its already starting to separate. I'll have to pull the covers, refoam, recover. A project for winter time. But I think it'll look much better once theyre properly stretched. Question - are they too plain? Should I get an interior trim piece like Clayton Machine sells?

Panels out -



Panels In with Seat -


And here are the panels before I sanded, trimmed, filled, and covered them up -