1969 Camaro LS7, 6 speed, Art Morrision full frame, C-5 rear IRS, 1 off camaro

[classiccarcustoms]

Sorry, Sold


Car is now painted Gloss black. Car was painted black, blocked down primed, blocked and primed and painted gloss black, very, very straight and mirror reflection.
Had all the door gaps aligned, all the stainless around the front and back window fit during body work.
You have to see this car in person... Pictures cant show 1/10 of detail and custom work.

1969 Camaro Ultimate Pro Touring build.
Over $200,000 invested. Car is currently painted Black, base coat, clear coat.

Tons of body mods and a lot of hand made metal. A must see.


Hand made metal hood.
Hand made grill with wire mesh.
Hand made front and rear bumpers that are both french-ed into the body. Nickle plated.
Hand made metal rear spoiler.
Block and primed 5 times.
Hand made cowl panel.
On and on.....

Chassis:
Art Morrison complete full frame. This frame is one of a kind.
It is channeled up into the body and has custom exhaust that runs through it for maximum ground clearance. You can still remove the body off the frame.

Front suspension:
Corvette C-5 front suspension. All New Not downer car.
All polished for show.
Spline sway bar.
Rack and pinion steering, also polished.
WilWood 14" 2 piece rotors and 6 piston calipers.

Rear suspension:
Corvette C-4 IRS.
Completely built to handle over 1000hp.
Over-sized axles and yokes. Also polished.
QA1 coil over.
Spline sway bar as well.

Polished 1/2 shafts and drive line also.

Stainless brake lines.

All custom floors, raised for frame to get channeled into body. Looks great. Painted bottom side and inside.

Engine:
LS7 (427) All aluminum.
All new, nothing used.
Should dyno around 780 hp.
AFR (230) polished heads that are also ported and polished.
Billet Kings crank.
Titanium rods.
JE pistons.
Custom Stack fuel injection system. Cost $4,500 alone.
1 off custom air cleaner and stainless pipe that runs to lower front air dam to draw cold air in. Air cleaner set up was all hand made and cost over $6,000. Once you see it you will know why.
All polished vintage Air belt set up.
Gen 4 Vintage A/C.
Fast EFI complete turn key wiring harness and ECM with hand held programer.


Transmission:
Customs built T56 6 speed. Also polished out.
New billet flywheel.
Dual friction clutch.
Custom Scatter shield also polished.

Hand made headers, coated.
Hand made complete exhaust system.
All joints are V bands for easy fast removal.
Cost $5,800. Must see.....



Custom hand made stainless gas tank.


-Ring Brother billet hood hinges (black).
-Ring brothers Billet door striker.
-Marqez Billet tail lights.
-Led turn signals.
-Marqez design Billet market lights.

Custom built aluminum radiator with dual fans.
Cost $2,800

Electric life power windows front and rear.
Custom Billet switches and wiring.


Hand made dash.
1 off custom gauges.
Hand made dash and doors panels.
Hand made center console. All out of metal.

Way to much to list..


New billet battery mounts in the trunk, new red top optima battery.
New American Auto Wire car wiring harness.
New Ididit push button start system. Completely wired in.

Dynomat the complete car, roof to floor.
Just bought all new smoked glass for the car.


What the car will need to be 100% complete.
-A/C and heater lines.
-Gas lines.
-Rims and tires. Will take a 18x11 with 305 in the front and a 18x13 in the rear with a 345.
-A couple brake lines.
-Interior.
-Finish the wiring.




There is so much done to this car, best is to call or come out and see the car.

Since these pictures, a lot has been done to the car.
Dash has been removed and body worked and painted, door panels the same.
Lots of wiring, The whole inside and out of the car is painted. Inside the doors, inner fenders. I have a complete hand made inner fender set up. Way, Way to much to list.


Wiring I have completed:
Push button start is complete.
Power trunk is complete.
Battery cables, + &- complete.
Battery shut off wired in.
Fuse box wired in.
Dome light circuit completed.
All radio wires ran.
Steering column wired in.
Brake light switch custom made and wired in.
Neutral safety switch custom made and wired in.
All rear tail lights wired in.
Power windows all wired in.
Door pops all wired in and work great.


May trade for C-10, crew cab, camaro, nova chevelle, land, motor-home, concert

I will try to get better pictures this week.

[mikey]

I like the injection setup. I think that it's comparable to the inglese setup

[06goatm6]

Awesome car, we may have talked on the phone a few months ago about my white C6. Bump for a sweet ride.

[classiccarcustoms]

Thanks,
Sent the car off last week to paint jail. I mean body shop. Having all the gaps and stainless around windows fitted and then painted Black.
Ordered up all the missing parts to finish, Hope to call Forgeline this week and order up some wheels and tires.

[JRZ]

I understand that you would be interested in trades. I have a 2004 911 C2 Cab 6 speed that is lowered with H&R springs and coil overs also Pilot sport tires and HRE rims. I also have the Porsche Aero kit (wing and side skirts.) Let me know if you would be interested.

Jason
cell#5198308835

[classiccarcustoms]

Thanks for the offer. I will pass.
Car finally got painted today. Here are some pictures right out of the paint booth.

[tkh60353]

can you send some pics of the car to [email protected]

[classiccarcustoms]

Car is now painted, frame off, show car. Black, wet sanded and polished. Not sure if it is still for sale. If it is, price went up of course.

Thanks

[classiccarcustoms]

Ebay item #181500783528

[classiccarcustoms]

Camaro is out of the body shop.
A lot more done on the car then in pictures. I will pull the car out this week and take current pictures.

[classiccarcustoms]

O.K Pulled the camaro out of the garage today and took some current pictures.
Cant even get 50% of the detail or parts in on the pictures.

[classiccarcustoms]

Please see more pictures on Ebay
Item # 181545758964

Thanks

[classiccarcustoms]

Sold

[tbarnes3]

What is your cash price and pictures