6 Attachment(s)
ATS/Speedtech suspension stuff for first gen Camaro or Firebird for sale
Attachment 57639Attachment 57640Attachment 57641Attachment 57642Attachment 57643Attachment 57644
Here is what I have for sale:
First Gen f-body frame (69' model I think). It was dipped to remove all grease and gunk from over the years. Upper shock mounts removed to allow install of ATS/Speedtech Chicane coil over brackets. Two of the frame mounts have had the holes partially repaired.They need the welds finish ground. I cleaned up alot of the welds and rewelded alot of the seams. I did this by welding like an inch at a time on opposite sides of the frame. I also have a set of tall ATS/Speedtech Spindles for a first gen F body or third gen X-body. These are tall versions. I have had them for about two years. They are stamped serial #00211. They have never been on a car. The hubs have some surface rust on them from setting in my garage. These were upgraded at ATS to have 1/2" x 3" ARP studs in them when I bought them. I also have the upper Chicane coil over brackets. They have been preliminary fitted, but not welded in. They have the spacers in them for Bilstein ASN coilovers. Along with this is a set of Global West lowers for coilovers. These were also modified at ATS and have the lower coil over mount already welded in. Also include are a set of Bilstein ASN series coil over shocks with the proprietary ATS valving. I have the adjusters for these as well. I don't have springs to go with them. I am also including a centerlink. I have the thinner version that came with my 67 Firebird as well as the thicker one that came with the frame. You can pick which one you want. Also going with it are a set of the rare short Z28 steering arms. The only issue with these arms is I got them from a street rod guy and he had smoothed them up with a roloc disc. So in the end a person would need upper a-arms, steering box, tie rod ends and adjusters, and coil springs (2.5 ID x 10") of their desired stiffness, and to install their steering col. to have a complete front suspension. Potential buyer would also need to finish fitting the coilover brackets, weld them in and finish the frame. I think there is enough material that you could even start over on another frame with them if you wanted to. This is a proven set-up as Jim Shipka (think One Lap Camaro) runs a similiar set-up. He uses a better coil over shock, and Speedtech arms I think. All this stuff is at my house in Indianapolis, In. [B]I don't want to deal with shipping this stuff. I shipped my first set of spindles that I had and they got dinged in shipping. So I prefer local pick-up.
Sep. the parts: Prices are listed in a post further down the list. Spindles are sold. to Roberts68. Thanks Again.
Steering Arms and rest of coil-over parts avalible. I am asking $150.00 plus shipping for the steering arms. I would take $900.00 for the Coilovers, Global West lower arms, and conversion brackets. If a buyer is close and wants it I will through in the frame for free!!
ATS/Speedtech suspension stuff for first gen Camaro or Firebird for sale
ATS/Speedtech suspension stuff for first gen Camaro or Firebird for sale
His post states Indianapolis .
