Dirtleg
11-01-2011, 02:45 PM
O.K. to start I have a Dana 60 rearend sitting around and want to replace the mopar 7.25" rearend in my 65 sport fury. It is a FF from a 1978 F250 (RIP).
What I want to accomplish is
1. I am going to narrow it. How much I am unsure of yet as I haven't taken any measurements.
2. I would like to keep it a FF but obviously am not going to be running 8 lugs on the car. Does anyone know of a spindle kit that can be used. I have seen some 9 inch FF's built and was wondering if those parts would be workable on this. Also who makes them?
I expect I'll get a line up bar and machine some pucks at work when the time comes. Just trying to figure out if I can actually accomplish what I want before getting into it.
And just to be clear I will be doing the work myself.
Thanks for any input.
Greg.
What I want to accomplish is
1. I am going to narrow it. How much I am unsure of yet as I haven't taken any measurements.
2. I would like to keep it a FF but obviously am not going to be running 8 lugs on the car. Does anyone know of a spindle kit that can be used. I have seen some 9 inch FF's built and was wondering if those parts would be workable on this. Also who makes them?
I expect I'll get a line up bar and machine some pucks at work when the time comes. Just trying to figure out if I can actually accomplish what I want before getting into it.
And just to be clear I will be doing the work myself.
Thanks for any input.
Greg.