Eric Howell
07-20-2011, 12:35 PM
I have a few questions so bear with me.
1)Does anyone have the front wms-wms measurement for a stock C5/6?
2)Are there any good measurements for pick up points on the net? Anyone willing to share theirs? I have been searching but all I seem to find is "download Suspension Analyzer" and it seems the measurements are off according to posts I have found here.
3)I understand that more camber gain may be better but how much more?
4)Is there any aftermarket UCA with a standard cross shaft and the reversed upper ball joint? Think a standard cross shaft would be much easier to use and possibly free up some room under hood.
My plan is to build a full frame for my S10 and the C5 front end seems to offer most of what I want with some fine tuning but I'm not sure if it will even work because of how much it may need to be narrowed. To run C5/6 rims (with adapters) the S10s wms-wms will end up at 59"+/- so that's what I'm shooting for. Going to purchase a suspension program in the coming months to figure out bumpsteer, RCH and everything else. Just looking for a starting point.
Any help is much appreciated.
1)Does anyone have the front wms-wms measurement for a stock C5/6?
2)Are there any good measurements for pick up points on the net? Anyone willing to share theirs? I have been searching but all I seem to find is "download Suspension Analyzer" and it seems the measurements are off according to posts I have found here.
3)I understand that more camber gain may be better but how much more?
4)Is there any aftermarket UCA with a standard cross shaft and the reversed upper ball joint? Think a standard cross shaft would be much easier to use and possibly free up some room under hood.
My plan is to build a full frame for my S10 and the C5 front end seems to offer most of what I want with some fine tuning but I'm not sure if it will even work because of how much it may need to be narrowed. To run C5/6 rims (with adapters) the S10s wms-wms will end up at 59"+/- so that's what I'm shooting for. Going to purchase a suspension program in the coming months to figure out bumpsteer, RCH and everything else. Just looking for a starting point.
Any help is much appreciated.